The parallel bus wires supply voltage along the entire length of the heater cable. A resistance wire heating element is spirally wrapped around bus wires contacting alternate bus wires at specific intervals forming heating zones. This series of parallel heating zones provides a constant power output for each zone, irrespective of where the cable is cut along the length of the bus wire. There is no change of power output with the change in temperature, anywhere in its recommended operating range.

Characteristics :-
Strong but flexible
No returning lead is required
Flat configuration enables efficient heat transfer.
Cut to length at site; no wastage
Easy termination and installation
Integrated cold end without joints
No inrush current

A. Low Temperature Cable Construction

S. No.	Element	Detail	Advantage
1.	Two parallel bus wire	1.5 sq. mm multistrand tin plated Copper	Flexible, Easy to Solder Max. temp. 150 Deg.C
2.	Primary Insulation	HR PVC	Max. temp. 105 Deg.C
3.	Heating element	Nicrome wire	Very low temp. coefficient
4.	Secondary Insulation	HR PVC	Max. temp. 105 Deg.C
5.	Shielding	Nickel Plated Copper braid	Chemical resistant Max. temp. 260 Deg.C
6.	Jacket (Optional)	HR PVC	For Corrosive Environment

Technical Data: -
Supply Voltage: 230 V (Other rated voltages can also be designed
Minimum environment temperature: Miuns deg.C
Minimum bending radius : 40 mm
Maximum Temperature withstand : 80 Deg. C
Minimum Space between turns : 40 mm (Should not be

Range :-

Part No.	Wattage watt/m	Max. Length (m)	Zone Length (m)	Max. Operating Temp. (deg.C)
CWPT10	10	150	1.50	180
CWPT20	20	125	1.00	150
CWPT30	30	100	1.00	140
CWPT40	40	75	1.00	120

B. High Temperature Cable Construction

S. No.	Element	Detail	Advantage
1.	Two parallel bus wire	1.5 sq. mm multistrand silver plated Copper	Flexible, Easy to Solder Max. temp. 200 Deg.C
2.	Primary Insulation	Tape Wrapped sintered PTFE	Max. temp. 260 Deg.C
3.	Heating element	Nicrome wire	Very low temp. coefficient
4.	Secondary Insulation	Tape Wrapped sintered PTFE	Max. temp. 260 Deg.C
5.	Shielding	Nickel Plated Copper braid	Chemical resistant Max. temp. 260 Deg.C
6.	Jacket (Optional)	Tape Wrapped sintered PTFE	For Corrosive Environment

Technical Data: -
Supply Voltage: 230 V (Other rated voltages can also be designed)
MInimum environment temperature: Miuns deg.C
MInimum bending radius: 30 mm
Moisture Resistant : Yes
Muximum Temperature withstand : + 240 Deg. C
Munimum Space between turns : 25 mm (Should not be

Range:-

Part No.	Wattage watt/m	Max. Length (m)	Zone Length (m)	Max. Operating Temp. (deg.C)
CWPP10	10	150	1.50	40
CWPP20	20	110	1.00	35