Construction
 |
| S. No. |
Element |
Detail |
Advantage |
| 1 |
Heating element |
Spirally wound Nicrome wire on glass fiber cord. |
Very low temp. coefficient Good Tensile Strength |
| 2 |
Insulation |
Tape Wrapped PTFE |
Max. temp. 260 Deg.C |
| 3 |
Shielding |
S.S. braid |
For Earthing and Mechanical Protection |
| 4 |
Cold Lead |
PTFE insulated SPC wire |
Low Contact resistance |
|
|
Technical Data
 |
|
Series Heater |
|
|
- Supply Voltage: 230 V AC (Other rated voltages can also be designed)
- Minimum environment temperature: Minus 55 deg.C
- Minimum operating surface temperature: + 260 deg.C
- Maximum bending radius: 6 x diameter
- Minimum Resistant: Yes
- Minimum O.D. : 3.0 mm ( Diameter at joints is higher)
- Type of joint: Water proof
Range
|
| Part No. |
Wattage watt/m |
Max. Operating Temp.(deg.C) |
Max. Diameter (mm) |
Heater Length (m)* |
| CWST10 |
10 |
260 |
3 |
According to Customer |
| CWST20 |
20 |
260 |
3 |
requirement |
|
|
Always specify heater length along with order.
Reliability
Water proof joints at each end of hot wire (heating
cables), increases reliability & is quite safe in operation.
